Priming enamel [SBE]-111 [UNIPOL]® the stamp B of [oprednaznachena] for the anticorrosive protection of structures, transportation means and equipment, and so the concrete surfaces: the being undergone action dry salts and alkalis, and so their concentrated and dilute solutions, sea and fresh water; exploiting due to the conditions of the industrial atmosphere of the moderate climate (at an operating temperature of ambient air from -45o[S] to +40o[S]), the period of anticorrosive protection - 10 [let]*; putting priming enamel is possible with the temperature of ambient air to -25o[S] and the high relative humidity of air. Anticorrosive protection: structures and the equipment for the productions of the mineral fertilizers; transportation means for the transportation of the mineral fertilizers; ship constructions, berthing facilities; reservoirs with the sea and fresh water; the underwater part of the vessels. Designation of the material Enamel [SBE]-111 “OF [UNIPOL]” stamp B Ground It is not required Thickness of coating, m 180 - 400 Quantity of the layers 2-4 Interlamination drying with +20o[S] less than 1 the hour 0o[S] 1 hour -5o[S] 2 hours -15o[S] 2 hours -25o[S] 1 hour Theoretical flow rate per 1[m]2, kgf 0,40-0,88 Cost 1 kgf of priming enamel, rub. 206,53 Cost of 1 sq. m., rub 82,61-181,75 * - conclusion [TSNIIPSK] [im]. Melnikov about the results of accelerated climatic testings of coating on the basis of single-component priming enamel “OF [UNIPOL]” ® stamp B (according to GOST 9.401-91, method 5), on the basis which system from the two-layered coating with a thickness of 180 m, substituted down the steel surface, purified down degree of 2 according to GOST 9.402-80, ensures the guaranteed period of the service of coating due to the conditions of the moderate climate of 10 years. Priming enamel [SBE]-111 [UNIPOL]® of stamp “B” has the following advantages over other paints: [odnokomponentnost] (simplicity before the application); it does not require base coat; the rapid time of drying; the possibility of putting with minus temperatures to -25o[S] and high relative humidity of air; the possibility of putting in any manner (airless, pneumatic, by brush, by roller); wide range on the compatability c by coatings on the basis of other paints; the possibility of application before the integrated systems of anticorrosive protection; the possibility of putting beyond the rusty surface when, beyond the surface of the metal, the tightly coupled rust is present, with the thickness is not more than 50 m; the production of priming enamel in three primary colors - black, red-brown, beige. Opinions and the testing: 1. RUP “ON [Belaruskaliy]” - conclusion on the laboratory cyclic tests of priming enamel [SBE]-111 “[UNIPOL]” ® of stamp B; 2. Privately held company “Of [sibalpindustriya] [GK] LIK” - the application of priming enamel “OF [UNIPOL]” ® of stamp B; 3. Joint stock company “Nevinnomyssk nitrogen” - the results of the analysis of the chemical resistance of coating on the basis of priming enamel “OF [UNIPOL]” ® of stamp B; 4. Joint stock company “caustic” - the protocol of technical conference about the results of the experimental-industrial tests of anticorrosive priming enamels of the stamp “OF [UNIPOL]” ® (including stamp b).

You look also: Record sheets of the technical tests Produced colors Technical description Instruction beyond the application To send claim for the enamel