Antifouling paint priming enamel [SBE]-111 [UNIPOL]® stamp AT is intended for the anticorrosive protection of structures and technological equipment: being undergone action elevated temperatures - to plus of 200o[S]; exploiting due to the conditions of the industrial atmosphere of the moderate and cold climate (at an operating temperature of ambient air from -60o[S] to +40o[S]); putting the anticorrosive system of priming enamel [SBE]-111 [UNIPOL] is possible at a temperature of ambient air to minus of 10o[S] and high relative humidity of air. Anticorrosive protection: petroleum-, gas- and the steam pipelines the chimney stacks the external surfaces of technological equipment (gas and mazut furnaces, steam generators, boilers) the system of the cold and hot water supply Designation of the material Enamel [SBE]-111 “OF [UNIPOL]” stamp AT Ground It is not required Thickness of coating, m 140 - 160 Quantity of the layers 2 Interlamination drying with +20o[S] less than 1 the hour 0o[S] 1 hour -5o[S] 2 hours -10o[S] 2 hours Theoretical flow rate per 1[m]2, kgf 0,35 Cost 1 kgf of priming enamel, rub. 189,31 Cost of 1 sq. m., rub 66,26 Antifouling paint priming enamel [SBE]-111 “OF [UNIPOL]®” of stamp AT has the following advantages over other paints: [odnokomponentnost] (simplicity before the application); it does not require base coat; the rapid time of drying; the possibility of putting at minus temperatures to minus of 10o[S] and high relative humidity of air; the possibility of putting in any manner (airless, pneumatic, by brush, by roller); wide range on the compatability with the coatings on the basis of other paints; the possibility of application before the integrated systems of anticorrosive protection; the production of the antifouling paint of priming enamel [UNIPOL] of stamp In different colors, about the agreement for the sake of the customer.

You look also: Opinions of organizations for all stamps Produced colors Technical description Instruction beyond the application To send claim for the enamel