ANTICORROSIVE PRIMING ENAMEL “[UNIPOL]” stamp [v] TU 2312-001-59846005-2003 Field of application Priming enamel [SBE]-111 [UNIPOL]® stamp [v] forms chemically resistant coating to the majority of highly aggressive media, including to the inorganic acids of average and high concentrations (sulfuric, salt, phosphoric, hydrofluoric and the like). Priming enamel is intended for the corrosion protection of metallic and ferroconcrete constructions, conduits, internal and external surfaces of capacities, which work before the aggressive media. Surface preparation of the concrete Concrete surface must be flat, clean and dry. According to SNIP (Construction norms and regulations) 3.04.03-85 the humidity of concrete is allowed not more than 4%. The surface of concrete must be evened and removed based on it lime milk, upper fragile layer of concrete and remainders of old coatings. After the surface treatment it is necessary to remove dust, sand, swarf and other pollution from the zone of painting. The presence on the concrete of the spots of the machine oil or other chemical compositions is inadmissible. Putting conditions Priming enamel is allowed to bring at an ambient temperature from 0o[S] to 35o[S] and with the high relative humidity of air. Method of the putting Priming enamel can be brought by brush, roller, methods of airless and air-stream atomization. Expenditure, the thickness of the coating The recommended thickness of coatings is 300-500 m depending on operating conditions. The theoretical flow rate of enamel for one layer 100 m composes tentatively 0,22 [kg]/[m]2, during the putting beyond the concrete surface - 0,34 [kg]/[m]2. Practical expenditure depends on many factors: the equipment used, the degree of preparation and complexity (form) of surface, weather conditions, qualification of personnel and so forth Ambient temperature, °[S] Time, ch 0 1 +20 to +35 less than 1 The time of interlamination drying indicated depends on number of the factors: the diluent used, the air circulation, ambient temperature, thicknesses film and the like and considerably it decreases with grow prettier ventilation, also, before open air. The complete set of the physicomechanical properties of coating occurs during 10-12 days (t=20oC, [f]=65%). Preparation of enamel at the point of the work Before the application of a component of enamel thoroughly they intermix throughout entire volume and mix up before relationship 1:1 (component of №1: the component of №2) as far as the volume. The obtained paint must be uniform before the color and the consistency. Before the putting to maintain not less than 10 minutes. Of for achievement necessary viscosity is allowed the dilution of enamel to 10% of the total volume. Xylene or solvent are used as the diluents. Cleaning container, tool Are used solvent, xylene, toluene. Storage Not to heat. To take care from the fire. Composition to store before the solidly closed container, protecting from the action of heat, the straight lines of the solar of rays and moisture. Guarantee period of storage before the hermetically sealed container of manufacturing plant - twelve months based on the day of production. For obtaining the additional information for the sake of the putting, the quality of surface preparation or in the case of obtaining the negative results during putting of priming enamel, to be turned at the point of the detailed consultation down the supplier